Acard ADR-7608C Manuel d'utilisateur télécharger pdf (Page 52)

After recording is stopped, system will prompt that the firmware uploading is successful; as

shown in the following picture. Press OK to confirm it.

Step 3: After complete, press ''Pre-Check'' to certify the firmware document; after the

certification is complete, a prompt window will jump out stating that the certification work is

successful. Press OK to confirm it.

Step4: Next, press “Burn” to start updating the firmware.

Warning: during the firmware-updating process, do not offline or turn off the browser; other

wise, it would cause error within the firmware-updating process that results in unable to

boot normally.

After the firmware updating is successful, a prompt window will jump out stating that the

certification work is successful. Press OK to confirm it.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 61 62

Pas de commentaire

Acard ADR-7608C Manuel d'utilisateur Page 52